clip in hot water boiler for most stoves 4-15kw

This is the small water jacket boiler that we often fit to our stoves. It needs to be fitted inside the stove, above the height of the rear flue outlet and replacing the baffle plate. The boiler will do the same job as the baffle plate by keeping the fire in the fire box and letting the smoke up the flue - but also creating heat to the wet side of the system as a by-product. A Stove must NOT be used with this boiler fitted if the water is not plumbed in. Therefore, only fit when you are ready to couple with radiators or hot water.

This boiler is for indirect fitting - ie if using a hot water tank - the tank must be coiled and inhibitor should be put in the system which prevents rust and sludge built up. Only suitable for non pressurised, open vented systems

 A standard radiator is classed as 600mm x 900mm single rail convector type, and in an 8kw stove, in normal conditions it can feed four to five of such radiators OR a hot water tank and two single 900mm rads.